Q-See QT5116 User Manual - Getting Started
GETTING STARTED
QT518 & QT5116 User Manual
10 |
P a g e
2.5 Control with Mouse
2.5.1 Connect Mouse
DVR supports PS/2 or USB mouse through the ports on the rear panel, please refer to Figs 2.6 and 2.7 Numbers 5
and 6.
Note: If mouse is not detected or doesn't work, follow these steps:
1. Make sure the mouse is plugged into the USB mouse port on the back of the DVR, not the front panel port.
2. Unplug then re-plug the mouse in a few times to see if it is detected.
3. Try a different mouse
2.5.2 Use Mouse
In Live View:
Double-click left button on one camera to enter full screen display. Double-click again to return to the previous screen
display.
Click right button to show the control bar at the bottom of the screen as in Fig 4.1 Control Bar.
Click right mouse again to hide the control bar.
In Setup:
Left click mouse button to enter setup screen. Right click mouse to cancel setup, or return to the previous screen.
If you want to input a value in the setup screen as shown in Figure 2.12 Input Screen, move your mouse curser over
the value you desire and click on it. The Input Screen supports numbers, letters and symbols.
Fig 2.12: Input Screen
Users can change some values by the wheel, such as time. Move cursor onto the value, and roll the wheel when the
value blinks then click down.