QTek 9000 User Manual - Leap Tab.
108
|
Getting Connected
To save battery power while connected to a Wi-Fi network
1.
On the
Settings tab of the Wireless LAN Main screen, move
the
Power Save Mode slider to a position that optimizes
performance with the least power consumption.
2.
Select the
Auto turn off WLAN if not connected check box to
allow your device to turn off the WLAN function automatically
when no signal is detected.
To increase security of the Wi-Fi network
The LEAP (Lightweight Extensible Authentication Protocol) feature
of Wireless LAN increases security on your device, and ensures that
nobody is able to access your network without your permission.
1.
On the Wireless LAN Main screen, tap the
LEAP tab.
2.
Tap
New.
By default, the LEAP screen displays data that you entered
previously. However, you can modify or delete the data as
required by tapping
Modify or Delete.
3.
Enter the SSID (Service Set Identifier).
4.
Enter the user name, password, and domain.
5.
Select an
Authentication Type.
By default, the
Authentication Type for your device is Open
System authentication.
Note
For LEAP to work correctly, both the access point and the receiving
device (your device) must be set with the same SSID, user name, and
password.