Quadro DECT-4200 User Manual - Dialling Mode (Tone / Pulse)
Resetting the handset (delivery state)
☞The handset will be resetted to the delivery state - the entries in the
phonebook, the caller list and the redial list will be deleted.
… press, select HANDSET using
and press
Select RESET and press
Confirm the safety request by pressing and enter the PIN (0 0 0 0
in delivery state and press ).
Dialling mode (Tone / Pulse)
☞You can switch the dial mode. In most situations the TONE option should be
selected.
… press, select BASE using
and press
Select DIAL MODE and press
Select TONE or PULSE and press or in the idle state
… press and hold for approx. 3 s. T (Tone) or P (Pulse) appears in the
display.
Flash time
☞You can set the flash time to 100 ms (usually for special services of your
telephone provider/delivery state) or 250 ms (e. g. for a telephone
exchange). In case of questions please contact your telephone
provider or the system administator of your PBX.
… press, select BASE using
and press
Select RECALL and press
Select SHORT or LONG and press or in the idle state
… press and hold for approx. 3 s. S (100 ms) or L (250 ms) appears in
the display.
System PIN
☞In delivery state the PIN is set to “0 0 0 0“. The PIN is valid for all registered
handsets.
… press, select BASE using
and press
Select SYSTEM PIN and press
Enter the old PIN and confirm by pressing
Enter the new PIN twice and confirm each by pressing
/
/
/
/
/
/
/
/
/
/
11
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
ENGLISH