Quadro DECT-4200 User Manual - Inserting The Batteries

Connecting the charging station

Connect the charging station to the mains. Ensure access to the power 

adapter plug is not obstructed by furniture or such. (Only applies to 

telephone sets with at least two handsets)

Inserting the batteries

Open the battery compartment cover. Put in the batteries. Close the 

battery compartment cover.

Attention: Use only type AAA NiMH 1.2 V / 450 mAh rechargeable 

batteries. Never use normal batteries / primary cell batteries. Observe the 

correct polarity!

Charging the batteries

 Before the handset is used for the first time, insert it in the base station 

/ charging station for at least 16 hours.

The handset warms up during the charging process. This is normal and 

does not represent a risk. The battery status is shown on the display. 

When the battery capacity is nearly exhausted, the battery symbol will 

flash in the display.

End your call and place the handset into the base or charging station for 

charging.

After a short time, the battery symbol will appear to be fully charged but 

this is actually not the case. The battery capacity will decrease rapidly. We 

advise you to put the handset on the base unit for 12 hours so that it can 

be recharged completely.

Setting the Language*

☞In delivery state the language is set to “English“.

… press, select HANDSET using  

  and press 

 /     Select LANGUAGE and press 

Select a language and press

* Option, not available in all models

☞

 / 

 / 

3

OK

OK

OK

OK

ENGLISH