1. DL manuals
  2. QUALIA & Co
  3. Amplifier
  4. INDIGO Series
  5. Owner's Manual

QUALIA & Co INDIGO Series Owner's Manual

Other manuals for INDIGO Series: Owner's Manual, Owner's Manual
Manual is about: Line amplifier

Summary of INDIGO Series

  • Page 1

    Owner's manual assembled in japan indigo series phono amplifier qualia & co. Of america.

  • Page 2

    Introduction thank you for purchasing the q ualia indigo series phono amplifier. Please read this owner's manual thoroughly before using the product so that its high-quality audio can be enjoyed for years to come. If you have any questions, please contact the dealer where you purchased the product o...

  • Page 3: Warning

    How to use audio equipment correctly before using the product, please read the safety precautions and owner's manual thoroughly and use the product correctly. Keep this owner's manual at hand for future reference. ● symbols the safety precautions and the product use various symbols to help users use...

  • Page 4

    3 indigo phono main unit (only one unit is shown for convenience sake.) mc input : rca connectors (special moving coil phono cartridge) output : rca connectors gnd : ground terminal power in (fischer connector): a connector used to connect the power cable from the indigo series power supply. Part na...

  • Page 5

    Power indicator indigo phono power supply (1) front panel (2) rear panel (3) power cables 4 120 5 power switch lch power outlet (fischer connector) rch power outlet (fischer connector) ac power inlet (15 amp iec type) fusebox voltage indication (operate the power supply only at the voltage indicated...

  • Page 6: Warning

    5 positioning and location of the units install this equipment in a location with adequate space for ventilation and heat release. If this equipment is installed in a location where it will be exposed to direct sunlight, extremely high temperature (for example near a heater), high humidity, or dust,...

  • Page 7

    6 main unit power supply main unit power supply spacer (1) installation recommended by qualia & co. The indigo phono amplifier main units are monophonic. Install the two units separately on a shelf of a rigid rack if possible. Install the power supply separately from the main units. (2) when install...

  • Page 8: Warning

    7 connection of power cable note: be sure to connect the power cable before connecting the ac power cord. Connecting cables in an incorrect order may damage the main unit and result in an electric shock. Be sure to connect the cables as described below. Warning connect the power cable into the power...

  • Page 9

    8 1. Set the power switch on the power supply to off. 2. Disconnect the ac power cord from the power outlet on the wall (or power strip). 3. While supporting the main unit with one hand, hold and pull the latching sleeve of the fisher connector of the power cable using the other hand. The lock is re...

  • Page 10

    9 ● when connecting a cable, confirm that the power cable is not connected. Connecting a cable with the power on may damage the main unit and the equipment to be connected, which may result in an electric shock. ● before connecting equipment, thoroughly read the instruction manual for each device an...

  • Page 11: Caution

    10 ● when connecting a cable, confirm that the power cable is not connected. Connecting a cable with the power on may damage the main unit and the equipment to be connected, which may result in an electric shock. ● before connection, thoroughly read the instruction manual of the turntable, moving co...

  • Page 12: Warning

    11 ● before connecting the ac power cord, confirm that cables are properly connected to input/output terminals and the power switch is set to off once again. ● do not place heavy articles on the power cord. Confirm that the cord is not crushed under this equipment. A damaged power chord can cause fi...

  • Page 13: Caution

    12 ● basic operation ● before turning on the power, confirm that cables are properly connected once again. ● before turning on the power, be sure to confirm that the volume of the preamplifier is lowered to the minimum. Turning on the equipment with the volume up may damage the speakers. (1) turn on...

  • Page 14: Warning

    13 (3) set the input selector of the preamplifier to the position of a device that the indigo phono is connected to. (4) set the volume to a desired level. Note: when the air is dry, release static electricity to the rack or something else. Then, operate the arm of the turntable and play the record....

  • Page 15

    14 ● there are many possible causes of humming noise or other noise. The indigo phono is a wide-band amplifier. It is sensitive to high-frequency noise generated on the power supply and digital noise generated on line cables. These noises are generated by various factors. ● digital noise often found...

  • Page 16: Warning

    Do not detach the rear cover of the main unit, cabinet, or cover. Do not modify this equipment. This device contains high-voltage parts. In order to prevent electric shock, please contact the dealer or the service department of qualia & co. For inspection, maintenance, or repair of the inner parts. ...

  • Page 17

    16 ● before requesting repair during use, some conditions that can be mistaken as a failure may occur. Before requesting repair, check the table below and go through the instruction manuals of the devices used with this equipment. If the cause of the failure is unclear, please contact the dealer you...

  • Page 18

    17 specifications gain : 68 db (1 khz) input impedance : 10 kΩ output impedance : 50 Ω input : special input/unbalanced terminal (rca) for mc x 1 output : unbalanced terminal (rca) x 1 power supply voltage : 120v ac (60 hz) power consumption : 42w external dimensions : main unit 400(w) x 105(h) x 30...