QUALIA & Co INDIGO Series Owner's Manual - Warning
5
Positioning and location of the units
Install this equipment in a location with adequate space for ventilation and heat release.
If this equipment is installed in a location where it will be exposed to direct sunlight, extremely high
temperature (for example near a heater), high humidity, or dust, a failure may occur even if heat is
released smoothly.
Do not install this equipment in such a location because, in a worst case scenario, it may result in a fire.
Do not place this equipment on an unstable surface, for example an unstable or uneven table.
When installed on an unstable surface, this equipment cannot perform its functions adequately.
Install this equipment out of the reach of children to prevent it from being dropped or knocked down,
causing an injury.
Secure sufficient space.
Install this equipment on a top panel of a rack if possible.
When installing this equipment on a middle shelf of a rack, be sure that there is at least 10 cm of clearance
from the top face of the Main Unit and 15 cm of clearance from the back side. Without these clearances,
heat remains trapped inside this equipment, resulting in a failure. In a worst case scenario, it may cause a
fire.
Install the Power Supply separately from the Main Unit. DO NOT place the Main Unit on top of the Power
Supply.
Do not place any objects on this device.
Do not place a vase, plant pot, glass, cosmetic product, container filled with medicine, water, or other
contents, or small metallic articles on this device.
If water spills or enters this equipment, it may result in a fire or electric shock.
Prevent any foreign matter from entering this equipment.
Do not insert or drop metals, burnable articles, or anything else into this equipment through the ventilation
hole on the Main Unit. It may result in a fire or electric shock.
Beware of small children. Install this equipment out of the reach of children if possible