QUALIA & Co INDIGO Series Owner's Manual - Warning
13
(3) Set the input selector of the preamplifier to the position of a device that the INDIGO PHONO is connected to.
(4) Set the volume to a desired level.
Note: When the air is dry, release static electricity to the rack or something else. Then, operate the arm of
the turntable and play the record.
If static electricity enters the INDIGO PHONO through the tone arm or cartridge, it may damage the
element of the input stage. Ensure that there is no risk of static electricity.
Set the volume to a desired level by gradually turning the volume control knob on the preamplifier clockwise (to the
right).
Notes for changing the cartridge
Before changing or replacing the cartridge, be sure to lower the volume of the preamplifier to the minimum level,
set the input selector to a position of a device that the INDIGO PHONO is not connected to, and turn off the power.
“Pay extra attention to this matter when using a universal type tone arm.”
Changing or replacing the cartridge with the volume increased may break the amplifier or speakers. QUALIA & Co.
will take no responsibility for any damage or problems caused by taking such actions.
(5) Turn off the power.
Turn off the power in the following procedure.
Lower the volume of the preamplifier to the minimum and set the input selector to a position of a device that the
INDIGO PHONO is not connected to. Turn off the power of the power amplifier and then turn off the power of the
INDIGO PHONO.
Procedure to turn off the power
Tips for enjoying higher quality sound
Install this equipment as recommended by QUALIA & Co. and keep it powered up at all times if heat release
is not a problem. In this condition, be sure to keep the volume of the preamplifier at its minimum level.
Since this equipment handles weak signals, it takes some time for the circuits to reach optimal operating
conditions. The best sound performance can be obtained by keeping the equipment always powered up.
Turn off the power of
the INDIGO PHONO
(this unit).
Lower the volume
of the preamplifier.
Set the input selector to a
position of a device that
the INDIGO PHONO is not
connected to.
When the equipment is not going to be used for a long period of time due to travel or other similar reason, remove
the power plug from the wall outlet for safety. Keeping the power plug in the wall outlet may result in a fire.
When pulling out the power plug, do not pull the power cord. It may damage the cord, resulting in a fire or
electric shock. Be sure to pull it out by holding the plug.
When there is a risk of power outage or lightning strike due to a typhoon, heavy rain, or thunder, be sure to pull
out the power plug of this equipment from the wall outlet. A sudden power outage or lightning strike can damage
the Main Unit and connected equipment, which may result in a fire or electric shock.
WARNING
Turn off the power
of the power
amplifier.