QUALIA & Co INDIGO Series Owner's Manual - Caution
12
●
Basic Operation
●
Before turning on the power, confirm that cables are properly connected once again.
●
Before turning on the power, be sure to confirm that the volume of the preamplifier is lowered
to the minimum.
Turning on the equipment with the volume up may damage the speakers.
(1) Turn on the power of the preamplifier or pre main amplifier.
First, confirm that the volume control of the preamplifier is set to the minimum level.
Then, set the input selector of the preamplifier to a position where no device is connected to the preamplifier.
CAUTION
(2) Turn on the power of the INDIGO PHONO.
Set the Power switch on the rear panel of the Power Supply to the right side viewed from the rear (left side viewed
from the front panel) to turn ON the power. Then turn on the power of the power amplifier.
This equipment is not equipped with a time muting circuit because of sound quality concerns.
Therefore, it takes approximately five minutes for each circuit to operate stably.
Order to turn on the power
Lower the volume of the
preamplifier, set the input selector
to a position of a device that this
equipment is not connected to,
and turn on the power.
Turn on the power of
the INDIGO PHONO
amplifier (this unit).
Turn on the power of
the power amplifier.
Power switch
Set to OFF
Set to ON
120
5
OFF
Main Unit Lch
Main Unit Rch
Power Supply
Power switch
Turntable
R
L
Rch MC Input
Rch Output
Rch Ground
Terminal
Lch MC Input
Lch Output
Lch Ground
Terminal
Grounding wire 2
Grounding wire 1
Preamplifier
R
L
INPUT
N
G
Wall outlet
L