QUALIA & Co INDIGO Series Owner's Manual - Warning
17
DO NOT detach the rear cover of the Main Unit, cabinet, or cover. Do not modify this equipment. This
device contains high-voltage parts. In order to prevent electric shock, please contact the dealer or the
Service Department of QUALIA & Co. for inspection, maintenance, or repair of the inner parts.
In case of an abnormal condition, such as smoke or an abnormal smell or sound originating from the unit,
immediately stop using this device. Turn off the power of all amplifiers on the system, turn off the Power
switch of this device, and pull out the power plug from the wall outlet. After confirming that the smoke has
stopped, contact the dealer or the Service Department of QUALIA & Co. for repair. Continuous use of this
equipment in such a condition may result in fire or electric shock.
If water or foreign matter enters this equipment, the equipment is dropped, or the cabinet is damaged,
immediately stop using the equipment. Turn off the power of all amplifiers on the system, turn off the
Power switch of this device, and pull out the power plug from the wall outlet. Then, contact the dealer or
the Service Department of QUALIA & Co. for repair. Continuous use of this equipment in such a condition
may result in fire or electric shock.
If the indicator goes off and operation stops, the fuse may have blown out due to some type of a problem
that occurred inside the device. In this case, immediately stop using the device. Turn off the power of all
amplifiers on the system, turn off the Power switch of this device, and pull out the power plug from the
wall outlet. Then, contact the dealer or the Service Department of QUALIA & Co. for repair.
●
When abnormal conditions occur
WARNING
• Replace the fuse only when instructed to do so by the Service Department of QUALIA & Co. QUALIA &
Co. is not responsible for any failure of the Main Unit or bodily harm caused by replacement of the fuse
without instruction from QUALIA & Co.
• Before replacing the fuse, be sure to pull out the power cord from the Main Unit or wall outlet. DO NOT
replace the fuse with the power cord connected to the Main Unit or wall outlet because it will result in
electric shock. QUALIA & Co. is not responsible for any bodily harm caused during the replacement of the
fuse.
How to Replace Fuse
When the fuse in the fuse holder blows out
Lower the volume of the device, turn off the Power switch on
the front panel, and pull out the power cord from the Main
Unit or wall outlet.
First, contact the Service Department of QUALIA & Co.
Explain to the person in charge that the fuse blew out.
•
Power supply variations are usually not considered to
blow out a fuse. However, the fuse may blow out due to
a variation a lot greater than expected, noise mixed in, or
significant interference by illegal wireless communications
along a road even when the Main Unit does not experience
any problems.
•
When instructed to change the fuse by the Service
Department of QUALIA & Co., disconnect the speaker
cables and perform the procedure described on the right.
After replacing the fuse, connect the power cord.
Turn on the Power switch.
If the newly replaced fuse blows out, the Main Unit may have
a failure. In this case, contact the dealer or QUALIA & Co.
Fuse: "6.35 mm dia. x 31.8 mm L 250 V 8 A" semi time lag
type
Press the cover of the fuse holder using a
slotted screwdriver and turn it counterclockwise.
Replace the blown fuse.
Fuse: 6.35 mm dia. x 31.8 mm L 250 V 8 A semi
time lag type
After replacing the fuse, press the top
cover using a slotted screwdriver and turn it
clockwise to lock it firmly.
Turn the cover
counterclockwise.
Turn the cover
clockwise.