Quality Craft M903L-48BHO/BDC Instruction Manual - page 10
10
MAINTENANCE
WARNING:
Disconnect power and unplug
the power cord before attempting any main-
tenance or cleaning to reduce the risk of fire,
electric shock or damage to persons. The
bulbs in your unit can become extremely
hot. Allow at least 10 minutes between turn-
ing off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
RISK OF FIRE: DO NOT EX-
CEED THE RECOMMENDED
BULB WATTAGE.
REPLACING THE FLAME
EFFECT LIGHT AND
LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of
fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 X 40W Type B-10 bulb
under log-set bed.
Step 3: Loosen and remove the burnt out
bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2
larger screws into the top left corner hole
and bottom right corner holes as shown in
the diagram. Secure the 10 smaller screws
into the remaining holes. Make sure the
screws are in the correct holes and have
been tightened.
M A I N T E N A N C E
Step 5: Plug in the unit.
REPAIR SET
TOUCH UP REPAIR PAINT
Paint directly on the mantel unit if
necessary. Fig. A.