Quality Craft M903L-48BHO/BDC Instruction Manual - page 6
6
A S S E M B LY I N S T R U C T I O N S
NOTE: Each plastic connector is pre-assem-
bled (pre-drilled) on the specific panels with
2 screws. If the KD screw(s) do not fit during
assembly, loosen the 2 (pre-drilled) screws
to adjust the Plastic Connector until the KD
screws are able to be installed. Tighten all
KD screws once all panels are assembled.
Step 1: Attach 12 plastic connectors to pan-
els C, D, E and F with 28 KD screws. Attach
8 shelve support pins to panel C, D, E and F.
See Fig. A.
Fig. A
Step 2: Attach 24 plastic connectors [X] to
panels G, H, I, J and L with 28 KD screws.
See Fig. B.
Fig. B
Step 3: Attach panel C and D to base panel
[B] with 4 KD screws. Attach panel E and
F to base panel (B) with 2 KD screws. See
Fig. C.
Fig. C
Step 4: Attach panel G to panels C, D, E and F
with 8 KD screws. See Fig. D.
Fig. D
Step 5: Attach panel H to middle panel [K]
with 2 KD screws. See fig. E.
Fig. E