Quality Craft M903L-48BHO/BDC Instruction Manual - page 8
8
Step 11: Attach 4 door hinges to Left and
right door [Q and R] with 8 mounting screws
[T] (2 screws for each hinge) as shown in
Fig K. Attach left and right door [Q and R] to
panel C and D with 8 mounting screws [T]
(2 screws for each hinge). See Fig. K. Attach
door handles [Rs] to left and right door with
2 door screws [Rt].
Fig. K
Step 12: Tighten all KD SCREWS.
FIREPLACE INSERT
INSTALLATION:
The fireplace insert can be installed after the
mantel has been fully assembled.
WARNING: Make sure the fireplace insert
controls are in the OFF position and the unit
is NOT plugged in.
Step 1: Carefully place the INSERT in the
unit opening. The front of INSERT should be
flush with the front of the mantel. Carefully
lift the INSERT into the mantel until the top
stopper is against the mantel.
Step 2: Attach 2 small brackets [M] at the top
of insert with 2 KD screws. Attach the
L-mounting bracket to Base panel with 2
short KD screws. See Fig. L.
Fig. L
Step 3: Move assembled unit to desired
location. Unit should not be positioned in
area exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm
all controls on fireplace are in the OFF posi-
tion. Plug the fireplace into a 15AMP/120Volt
outlet. If the cord does not reach, you may
use an extension cord rated for a minimum
A S S E M B LY I N S T R U C T I O N S