RAD B- 2.5 User manual - page 14
B-RAD 2.5 USER MANUAL
New World Technologies Inc.
Page • 12
V2014.07.03
INCORRECT:
The foot of the Reaction Arm is too short on the left side, and too long on
the right side.
Figure 3.1.3-2: Incorrect Length
Please contact New World Technologies Inc or your local RAD Authorized Distributor for
custom Reaction Arms.
3.1.4 Reaction Points
Ensure the Reaction Arm reacts off the middle of the foot as seen in Figure 3.1.4-1. Do not
react off the heel of the reaction foot as seen in Figure 3.1.4-2.
CORRECT
: Reaction Arm is reacting off the middle of the Reaction Arm’s foot.
Figure 3.1.4-1: Correct Reaction Point
INCORRECT
: Reaction Arm is reacting off the heel of the Reaction Arm. This can cause
premature tool failure.
Figure 3.1.4-2: Incorrect Reaction Point
3.2 Torque Operation
To operate the Torque Cycle:
1. Refer to the Torque Chart to determine the desired Torque and Setting.
2. Change the Setting Dial (Figure 3.2-1).
3. Ensure the High(2)/Low(1) Switch is in the High(2) Position (Figure 3.2-2).