Radenso Pro Series User Manual - Installation
Page 4
Installation
The Radenso Pro windshield mount allows a firm and secure installation of the radar detector at the windshield
of your vehicle. Locate an area at the windshield that enables an unobtrusive installation with clear view to the
road ahead.
1. Place the nipple of the suction cups in the
large hole of the bracket und pull the suction
cup into the small hole to secure them. Push
the rubber damper into the hole in the
middle of the bracket
Rubber damper
2. Attach the windshield mount to the desired area of the windshield. Make sure it is in a level
position parallel to the road ahead. To adjust the angle if necessary, gently push or pull on the
bracket to bend it. DO NOT use the detector to bend the bracket.
3. Insert the windshield mount into the slot at
the front of the detector until it is locked in
position
For firm and secure adherence to the windshield keep windshield and suction cups clean
4. Plug the small end of the power cable into the detetcor (located on the left side) and the large end into
your vehicle’s 12V ACC socket.
5. To remove Radenso Pro from the windhield press the release button on top of the unit and slide the unit
off the mount.