Radenso Pro Series User Manual - Setting Autocity Speed
Page 7
Setting AutoCity speed
The AutoCity driving mode allows the setting of minimum alert detection speed for signal suppression AND
signal filtering resulting in 90% reduced false alerts. Select AutoCity in Setting Mode
Setting AutoCity speed: (feature selectable only if Setting Mode is set to AutoCity):
Tapping the Middle button lets you select the speed for editing
Left speed setting indicates the speed below which the radar reception of the detector will be completely
disabled (in example above 20 mph). No signals from police radar or false signals from automatic door
openers will be reported.
The right speed setting indicates the speed below which the detector will detect alerts in City mode with
reduced radar sensitivity (in example above 40 mph).
+ / -
buttons on the right side of the detector will change the specific speed setting.
RECOMMENDATION “20” and “35”
The detector will not alert to any signal below 20 mph and will
operate with reduced radar reception between 20 and 35 mph. Maximum detector sensitivity will be
achieved above 35 mph.
Setting City and AutoCity sensitivity (this option is available only in City or AutoCity Mode):
By means of the
Middle button
you can select the radar band for editing.
To change the sensitivity of signal reception use
+ / -
button on the side of the unit. The level of signal
suppression can be selected in the range 0-9. The displayed numbers indicate the sensitivity reduction in
the different radar bands. The example displayed above indicates that the X Band sensitivity is reduced by
50%, K Band sensitivity reduced by 20% and Ka Band sensitivity is not reduced at all (0% reduction).
SpeedMeter Mode:
This function is intended for legal operation of Radenso Pro in countries or states where the use of radar
detectors is not permitted. The detector stops alerting to POI GPS locations as well as all radar and laser
signals and the device is only displaying the travel speed and heading. To activate this function you need to
simultaneously hold the
middle
and
right button
for approximately 5 seconds. After that you will enter into
SpeedMeter Mode and all POI, radar and laser warnings are disabled. To deactivate SpeedMeter and to
reactivate the full function of Radenso Pro again you need to hold the
right button
and the
+ button
and
then plug the unit into a power source. You need to hold the buttons for approximately 8 seconds. After 8
seconds the display will show SpeedMeter OFF and radar-, laser- and POI detection is reactivated again.