Radiforce RX350 Installation Manual - Leaves The Monitor
25
Chapter 5 Power Saving Functions
5-3. Setting DisplayPort Power Save
If the PC is connected to the DisplayPort connector, and when the power is turned on or off or when the
monitor recovers from power saving mode, window or icon positions may be shifted. If that occurs, set
this function to "Off".
Procedure
1. Select to turn off the monitor power.
2. While holding down the switch at the far left ( ), touch for at least two seconds to turn on the
monitor power.
The “Administrator Settings” menu appears.
3. Select “DP Power Save” from “Administrator Settings”, and choose .
4. Select “On” or “Off” with
or
, and choose .
5. Select after completing the setting.
5-4. Setting the Power Saving Mode When a Person
Leaves the Monitor
The sensor on the front side of the monitor detects the movement of a person by setting Presence Sensor
to On. When a person moves away from the monitor, it shifts to power saving mode automatically and
does not display the images on the screen to reduce the power consumption. When a person comes near
the monitor again, it recovers from the power saving mode and displays the images. The sensitivity, and
time until the power saving mode is activated can be set according to the monitor usage environment and
movement of the user.
Note
•
At the time of shifting to power saving mode, the message that indicates shifting is displayed.
Attention
•
This setting cannot be used during “RadiCS SelfQC” execution.
Procedure
1. Select “Preferences” of the Adjustment menu, and choose .
2. Select “Presence Sensor” from “Preferences”, and choose .
3. Select “On” or “Off” with
or
.
4. Select after completing the setting.
5. If you have selected “On”, configure the detail settings.
Item
Setting Range
Description
Time
5, 30 sec
1, 3, 5, 10, 15, 30, 45,
60 min
Specifies the time from when a person leaves the monitor until
the “No presence detected.” message appears. The monitor shifts
to power saving mode about 20 seconds after the message is
displayed.
Sensitivity
Level 5
Level 4
Level 3
Level 2
Level 1
When the setting level is high (“Level 5” at maximum), even minor
movements of a person are detected, causing the monitor to shift
to the power saving mode only infrequently. On the other hand,
when the setting level is low (“Level 1” at minimum), only major
movements of a person are detected, allowing the monitor to shift
to power saving mode sooner. The presence sensor on the front
side of the monitor functions by detecting the movement of heat.
Consequently, the sensitivity is affected by clothes and the ambient
temperature. If the monitor enters power saving mode or recovers
from it unintentionally, change the settings.
Reset
-
All adjustments are reset to the default settings.