Radionics D8024 Operator's Manual - page 14
© 1998 Radionics, Inc. All rights reserved.
® The Radionics logo is a registered trademark of Radionics, Inc.
1800 Abbott Street, Salinas, CA 93901, USA
Comments? Suggestions? E-Mail: techwriters@radionicsinc.com
View Devices
•
Option one on the View Menu allows the operator to view the current state and text of any one device on a circuit.
Select option one, 1) Devices, from the View Menu. The display prompts for the loop (circuit) number. Key in the
circuit number and press Enter. The display prompts for the address. Key in the address and press Enter.
VIEW: 1) Device 2) Log 3) Faults
4) Outputs 5) Disablements 6) Sys Events
Figure 18: View Menu
View Event Log
•
Option two on the View Menu allows the operator to view the Event Log. Select option two, 2) Event log, from the
View Menu and pressEnter. The display prompts a beginning entry number. The default is the latest entry. Press
Yes to accept. Press No to select another entry. Use the >/< Keys to scroll through the log. Exit this menu by
pressing the No key.
View Faults
•
Option three on the View Menu displays the panel fault status. This is the same display as the normal Alphanumeric
Display without the logo. The operator may scroll through all the faults using the >/< Keys. Exit this menu by
pressing the No Key.
View Outputs
•
Option four on the View Menu displays information on disabled devices.
Using the Alarm Silence Key forces all notification appliances to an OFF condition.
View Disablements
•
Option five on the View Menu displays information on disabled devices.
9.0
Level Three (Programmer) Functions
•
See the Analog Fire Alarm Control Panels Programming Guide (P/N:38789B) for complete information on
commissioning and programming the Fire Alarm Control Panel. Commission, configure, networking, and certain
disable options are not available to level two operators.