RADVision Scopia Elite 5100 Series Installation Manual - page 27
Setting up the MCU | 23
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Marking the Location of the Device-fixing Cage Nuts
There is an extra pair of cage nuts for each front-facing rack post. You need these cage nuts to
fix the device brackets to the post.
Before attaching the cage nuts to the rack, mark where you plan to attach them, so you can be
sure they are level and properly placed.
Procedure
Step 1
From inside the front-facing rack post, mark the location of the lower device-fixing cage nut
measured at 0.20 inches (0.5 cm) above the shelf. See
Figure 4-9 on page 23
.
Figure 4-9
Marking the location of the device-fixing cage nut on the rack
Step 2
Mark the location of the upper device-fixing cage nut measured at 1.46 inches (3.7 cm) above the
shelf. See
Figure 4-9 on page 23
.
Step 3
Repeat this procedure for the other front-facing post.