RADVision Scopia Elite 5100 Series Installation Manual - page 42
Performing the MCU Initial Configuration | 38
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Step 5
Select Locate automatically to instruct the MCU to automatically locate one of the SIP servers
that are present in the domain,
or
Select Specify and enter the following:
•
An IP address or host name of the SIP server, for example
Figure 5-7
SIP Protocol section of the Protocols tab
•
The communication port number of the SIP server address. The default port is 5060.
•
The transport connection type.
The default is UDP.
Figure 5-8
Type list
Note:
The Locate automatically option works only if you have configured a valid IP address at
Configuration > Setup > Network > DNS server1 or DNS server2.
Step 6
To instruct the MCU to register with a SIP registrar and to send service information to the
registrar, perform these steps:
a.
Select Use registrar.