RADVision Scopia Elite 5100 Series Installation Manual - page 47
Performing the MCU Initial Configuration | 43
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring Ports on All Models of the SCOPIA Elite MCU
This section provides instructions of how to configure the following ports and port ranges on the
SCOPIA Elite MCU 5000 Series, including the SCOPIA Elite 5100 Series MCU and the SCOPIA Elite
5200 Series MCU:
•
Limiting the UDP Port Ranges for RTP/RTCP on the SCOPIA Elite MCU ............... page 43
•
Configuring the TCP Port Range for H.245 on the SCOPIA Elite MCU .................. page 44
•
Configuring the HTTP Port on the SCOPIA Elite MCU..................................... page 45
•
Configuring the UDP Port for RAS on the SCOPIA Elite MCU............................. page 47
•
Configuring the UDP Port for the Gatekeeper on the SCOPIA Elite MCU .............. page 48
•
Configuring the TCP Port Q.931 on the SCOPIA Elite MCU............................... page 48
•
Configuring the TCP/UDP/TLS Port for SIP on the SCOPIA Elite MCU.................. page 50
Limiting the UDP Port Ranges for RTP/RTCP on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated UDP ports 12000-13200 (for video) and
16384-16984 (for audio) for RTP/RTCP. To provide additional security for your firewall, you can
limit these ranges.
Every call uses two audio ports and six video ports. For highly utilized systems (above 90%), we
recommend multiplying the number of total ports (for all calls) by a factor of 1.5.
Using its full capacity, the SCOPIA Elite 5100 Series MCU uses 180 ports for audio and 540 ports
for video, and the SCOPIA Elite 5200 Series MCU uses 360 ports for audio and 1080 ports for video
(except for the SCOPIA Elite MCU 5215, which has the same capacity as the SCOPIA Elite 5100
Series MCU).
Procedure
Step 1
Navigate to the MCU Advanced Commands section by doing the following:
a.
Select the
icon.
b.
Select Advanced parameters.
c.
Locate the CLI section and select More (see
Figure 5-13 on page 44
).