RAINSMART RainSmart User Manual - page 17
7
Tank empty and no mains
water supply
Perform General Test B2 (Verify float sensor)
Perform General Test D (Verify Mains Valve operation)
8
Mains water/Tank water
indicator incorrect
Verify rain water level in tank
Perform General Test B2 (Verify float sensor)
9
No water on dedicated rain
water tap
Check the rain water level in tank. May be too low
Check
RainSmart
TM
: if it indicates mains water and there is still a reserve level, change
RainSmart
TM
Pump mode to Manual.
Perform General Test A
Perform General Test B (Verify Rain water level)
Perform General Test B2 (Verify float sensor)
Perform General Test E (verify pump outlet)
10
No water to Laundry & Toilets Check Rain Water level & Float operation
Perform General Test B (Verify Rain water level)
Perform General Test B2 (Verify float sensor)
Tank empty & “Mains Water” indicator ON
Perform General Test D (Verify Mains Valve operation
TABLE 2 - GENERAL TESTS
The following general tests must be used in conjunction with TABLE 1 – FAULT CONDITIONS.
Please refer to TABLE 1for trouble shooting tips.
Test
Conditions - Suggested Resolutions
G
en
er
a
l
T
es
ts
A
Verifying
RainSmart
TM
Power
Is the
RainSmart
TM
Plugged in and switched on
Are any
RainSmart
TM
indicator lights
Power Ok
Verify using another appliance (i.e. hairdryer) that the power outlet is operating.
If power at outlet and no power on
RainSmart
TM
,
RainSmart
TM
may need repairs
If NO power at outlet seek advice from a qualified electrician
B
Verifying Rainwater
level
Rainwater level in tank Ok
RainSmart
TM
“Rain Water” indicator ON?
Check Float sensor is correctly installed?
Possible Float sensor Failure?
Rain water tank low
RainSmart ”Mains Water” indicator should be ON! And
RainSmart
TM
operating
on mains water.