Raleigh Bosch Cruise User Manual - 1   Quick  Start

V User Manual Impulse Pedelec 

  9

1   Quick  start 

›

1.  Charge the battery completely before riding for 

the first time. Charge temperature: 0 – 45°C

›

2.  Swivel the round charging socket cover on the 

battery to one side. 

Now insert the four-pole plug of the charger into 

the battery charging socket. 

Charging the battery

›

3.  Insert the mains plug for the charger into the 

socket.  

You must fully charge the battery before using it for 

the first time.

›

4.  Once all LEDs on the battery have gone out, pull 

the charger plug out of the battery socket. Swivel 

the cover back over the charging socket. 

You can also remove the battery from your Pedelec 

and charge it in the docking station. For more infor-

mation, refer to 

➠

 Chapter 4 “Charging the battery”

.

›

5.  If you have charged the battery in the docking 

station, reinsert the battery into the holder on the 

Pedelec from the left-hand side. Tilt the battery 

outwards at an angle of roughly 45° as you do so, 

as you did when you took it out of the holder. Move 

the battery into the upright position until the lock-

ing mechanism engages. If the key is still in the 

lock, you will need to turn it clockwise and pull it 

out as otherwise the battery will not lock in place. 

›

6.  Make sure that the battery is securely posi-

tioned and that the key is no longer in the lock.

  If your Pedelec is equipped with an LCD control 

panel:

›

7.  Push the Power button on the control panel on 

the handlebar.

›

8.  The display panel now displays the medium 

power-assist mode 

SPORT

. Press the arrow but-

tons to select the level of assistance: 

STAND BY

(off), 

ECO

 (low), 

SPORT

 (medium) or 

POWER

 (high). 

Press this button once to change the level of assis-

tance by one level. This works both ways, depend-

ing on which arrow button you press.

  The following applies for bikes which are equipped 

with a back-pedal brake:

›

9.  The system will now perform a system check. 

“Please move the pedals” will appear on the 

screen. If you set off now the system will normally 

detect a pedal movement in the “drive” and “back-

pedal brake” directions. This completes the safety 

check, and you can ride as normal with assistance. 

  If you cannot feel any assistance, simply back-pedal 

briefly and then pedal forwards again to trigger the 

system check. If there is still no assistance being 

delivered, the instruction “Please move the  

pedals” will continue to be displayed. In this case 

you should consult a specialist dealer.

You can now ride off just as you would if you were  

riding a normal bike. The motor starts providing  

assistance as soon as the rear wheel starts turning.