Raleigh ebike User Manual - page 255

 English–5

Bosch eBike Systems

0 276 001 X45 | (28.9.11)

For both versions, the lighting is switched on by 

pressing the “light” button 5. The lighting indi-

cator b appears on the display.

To switch off the lighting, press the “light” but-

ton 5 again; the lighting indicator b goes out.

Speed and Distance Indicators

Note: Depending on country-specific version, dis-

tance and speed can either be displayed in “km” 

and “km/h” or in “mi” and “mph”. Adjustment of 

the drive HMI and the selection of the display pos-

sibilities for the km and mile version are identical.

The speed indication a always displays the cur-

rent speed.

The following indications are available in multi-

function indicator e:

Total distance “odo”: Indi-

cates the total distance cov-

ered with the eBike

Trip distance “trip”: Dis-

tance covered since the last 

reset

Average speed “avg”: Aver-

age speed achieved since 

the last reset

Range “range”: Estimated 

range of the available bat-

tery charge (for constant conditions such as as-

sistance mode, assistance level, route profile 

etc.)

To switch within the multi-function indicator, 

press the “info/reset” button 3 until the desired 

function is displayed.

To reset the trip distance “trip” and the average 

speed “avg”, switch to one of both indications 

and then press the “info/reset” button 3 until 

the indication is reset to zero.

While using the start-assistance function, multi-

function indicator e goes out.

Error Code Indication

The components of the eBike drive are continu-

ously and automatically monitored. When an er-

ror is detected, the respective error code is in-

dicated in display f.

Depending on the type of error, the drive is au-

tomatically shut off if required. Continued travel 

without assistance from the drive is possible at 

any time. However, have the eBike checked be-

fore attempting new trips.

f

Have all inspections and repairs carried out 

only by an authorised bicycle dealer. When 

an error is still displayed despite corrective 

measures, please also refer to an authorised 

bicycle dealer.

Code

Cause

Corrective Measure

001

Internal error of the drive HMI Have the drive HMI checked

002

One or more buttons of the 

drive HMI are blocked.

Check if any buttons are blocked, e.g. from dirt or 

debris. Clean the buttons, if required.

003

Connection problem of the 

drive HMI

Have connections and contacts checked

100

Internal error of the drive unit Have the drive unit checked

101

Connection problem of the 

drive unit

Have connections and contacts checked

102

Error of the speed sensor

Have the speed sensor checked

103*

Connection problem of the 

lighting system

Have connections and contacts checked

* only for eBike lighting via battery (country-specific)

OBJ_BUCH-1557-001.book  Page 5  Wednesday, September 28, 2011  11:39 AM