RAMSET D60 Operator's Saffety & Operating Instruction Manual - Tool Operating Instructions
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
4. Close the cover and be sure it is
locked.
NEVER
attempt to make a
fastening with the tool cover in the
open or unlocked position.
5.
Hold the tool perpendicular (90°) to
the work surface with both hands
and press firmly to fully depress the
tool. Maintain firm downward
pressure on the tool with both
hands and pull the trigger to drive
the fastener.
DO NOT DEPRESS
THE TOOL AGAINST ANYTHING
OTHER THAN THE INTENDED
WORK SURFACE.
Holding the tool
firmly in place will produce more
consistent fastening quality and
minimize tool wear or damage.
6.
After making the fastening , with the
tool pointed in a safe direction, pull
the barrel fully open.This resets the
piston for the next fastening.
Always keep fingers and other
body parts away from the
muzzle end of the tool.
7.
Insert another fastener in the
muzzle end of the tool as before
and the tool is ready for the next
fastening. Keep your finger off of the
trigger until the tool is in position to
drive the fastener.
8.
To remove a used or partially used
load disc from the tool, open the
cover and lift out the load disc.
NEVER
try to remove a jammed or
stuck load disc. Should a “jammed”
load disc occur, call your local
Authorized Ramset Distributor for
technical assistance.
INSERT LOAD DISC INTO THE
SLOTS IN THE RECEIVER
HOLD TOOL FIRMLY AND PER-
PENDICULAR TO WORK SURFACE
OPEN AND CLOSE THE BARREL
AND INSERT THE NEXT
FASTENER
REMOVE THE LOAD DISC
3.
With the tool barrel closed to the
semi-closed position and finger
away from the trigger, open the
cover by pressing the side button,
and insert a load disc into the slots
in the receiver housing.