RAMSET D60 Operator's Saffety & Operating Instruction Manual - page 12
D60L CONVERSION / TOOL MAINTENANCE
D60L CONVERSION / TOOL MAINTENANCE
12
The standard D60 tool can be
converted to the D60L tool for use in
setting the 1516 (2 1/2” long) drive pin
and the 1524SDB (3” long) washered
drive pin by installing a special muzzle
bushing and outer barrel that are longer
than those on the standard tool.
Tool part changing
1.
Slide the barrel assembly forward to
expose the outer barrel clip and
carefully remove the clip with a
screwdriver or long fastener. Take
care that the clip does not fly away
when freed from the outer barrel.
2. Remove the standard outer barrel
shroud and muzzle bushing and slide
the new muzzle bushing into the new
longer outer barrel.
3. Align the slots in the outer barrel
shroud and the rear barrel, slide
together and replace the barrel clip.
Function test the empty, unloaded
tool to be sure the assembly is
installed correctly.
REMOVE THE BARREL CLIP
REPLACE THE OUTER BARREL
AND MUZZLE BUSHING
REPLACE THE BARREL CLIP
MAINTENANCE
IMPROPERLY MAINTAINED TOOLS CAN CAUSE SERIOUS INJURIES TO
TOOL OPERATORS AND BYSTANDERS
CLEAN TOOL DAILY
Always make sure that the tool is not loaded before performing any service
or repair. Always wear safety goggles when cleaning or servicing the tool.
NORMAL CLEANING
All front end parts shown in the disassembly section are to be cleaned daily with a
good detergent oil and wire brush. Remove all dirt and carbon buildup and wipe the
parts dry with a clean rag. Check all parts for wear or damage before reassembly
and replace any worn or damaged parts.
COMPLETE CLEANING / GENERAL MAINTENANCE
Heavy use or constant exposure to dirt and debris may require that the tool be
cleaned more extensively. Complete disassembly and cleaning of all parts may be
necessary to restore the tool to normal operation. General maintenance should be
performed every six months or more often if the tool is subjected to heavy use.
Contact your authorized Ramset Distributor for assistance.