RAMSET D60 Operator's Saffety & Operating Instruction Manual - Tool Operating Instructions
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
TOOL OPERATION
Daily Function Test
Always check the tool first to make
sure that it does not contain a load
disc or fastener.
Test the tool several
times by depressing the muzzle bushing
fully on a hard surface and pulling the
trigger. You should hear an audible click
as the firing pin releases. Let up on the
tool and check to be sure that the barrel
has opened to the semi-closed position.
PERFORM FUNCTION TEST
WITH EMPTY, UNLOADED TOOL
OPEN BARREL TO THE FULL
OPEN POSITION
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL
WITH THE POINT OUT
OPERATING THE D60 TOOL
1
.
After checking to be sure that
the tool is not loaded, point it in a
safe direction and be sure that
the barrel is fully extended. This
assures that the piston is in
position for the next fastening.
Use the spall guard every time
possible to minimize the risk of
being struck by flying debris.
2.
Slide the barrel to the semi-
closed position.
NEVER
place
your hand, fingers or any
other part of your body over
the muzzle (fastener loading
end) of the tool.
3.
With finger off the trigger, place
the fastener, point out, into the
muzzle end of the tool until the
point end is inside the muzzle.
NEVER
load a fastener with
your finger on the trigger.
DO
NOT
use excessive force when
inserting a fastener.
STOP
immediately if excessive force is
required, inspect the barrel to
find out why the fastener is not
entering the muzzle freely.
DO
NOT
continue loading unless
the problem is corrected.
CLOSE BARREL TO THE
SEMI-CLOSED POSITION