RAMSET D60 Operator's Saffety & Operating Instruction Manual - Disassembly
DISASSEMBLY
DISASSEMBLY
17
UNSCREW THE FIRING CHAMBER
5.
Slide the barrel assembly from the
outer barrel shroud and muzzle
bushing.
6.
Unscrew the firing chamber from the
barrel. NOTE: When ready to
reassemble the firing chamber, do
not screw it on tightly to the barrel so
that it can be readily aligned with the
slot in the receiver.
7.
Remove the piston from the barrel by
pulling straight outward. If necessary,
the piston can be removed by using
a rod inserted through the opening in
the rear of the barrel.
8.
Inspect all parts for wear or damage
and clean or replace as required.
Use detergent oil and cleaning brush.
Wipe parts dry before reassembly.
WEAR SAFETY GOGGLES WHEN
CLEANING TOOL PARTS.
9.
Check the piston tip for mushroom-
ing or other deformities, and grind
flat. The tip of the piston must be 90°
to the shank and grinding must only
be done by qualified personnel. The
overall minimum length of the piston
must not be less than 5 13/16”. When
less than this length, the piston must
be replaced to avoid tool damage.
10.
Reassemble the tool in the reverse
order of disassembly.
ALWAYS PERFORM THE DAILY
FUNCTION TEST BEFORE
USING THE TOOL AFTER
CLEANING OR SERVICING.
REMOVE THE PISTON FROM THE
BARREL
GRIND THE PISTON TIP FLAT
AND AND BEVEL THE TIP EDGE
AT 18°
REMOVE THE BARREL ASSEMBLY
FROM THE BARREL SHROUD