RAMSET JET Instruction Manual - Jet
RAMSET
www.ramsetinc.com
JET
6
POSITIvE STOPS AND EMERGENCY RELEASE
Adjust on the open position
Adjust on the closed position
EMERGENCY RELEASE
The emergency release handle is located on the top of the jet
arm. Insert the key into the emergency release handle and turn
it in order to unlock the release handle. The release handle can
now be raised in order to disengage the operator (see figure A).
The gate can now be opened and closed manually. To reengage
the emergency release handle: Lower the release handle back
into position and turn the key to lock it.
POSITIvE STOPS
The positive stops for the jet operator are lo-
cated on the undercarriage of the jet arm. Set
the positive stops using the following method.
1) Use a hex/ allen wrench to loosen the posi-
tive stops at the front and back of the under-
carriage (See figures B and C). Once loos-
ened, slide the forward stop all the way to the
front and the rear stop all the way to the back.
2) Lift the emergency release handle so that
the gate can move freely.
3) Push the gate all the way to the closed po-
sition and then slide the front positive stop
forward until it contacts the screw arm bolt.
Tighten the positive stop into place.
4) Push the gate all the way to the open posi-
tion and slide the rear positive stop back un-
til it contacts the screw arm bolt. Tighten the
positive stop into place.
The positive stops are now set. Close the gate
halfway and reengage the emergency release
handle. The operator is now ready to begin
programming mode through the Star 24 Con-
trol Board.
Figure A
Figure B
Figure C
The breaker or all power should be turned off before using
the emergency release.