Rangemaster 110 Ceramic User Manual - page 23
23
Electrical Connection
This appliance must be installed by a qualifi ed
electrician to comply with the relevant regulations
and also the local electricity supply company
requirements.
Make sure that the mains characteristics (voltage,
nominal, power, etc.) match the ratings indicated on
the data plate affi xed to the lower right hand cooker
upright (remove storage drawer). The cooker is preset
for a single-phase earthed electrical connection. It
is essential to install a multi-pole circuit breaker that
completely disconnects the appliance from the mains,
with a minimum contact break distance of 3mm.
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an effi cient
earthing circuit. If the electricity network is not equipped
with an earth connection, then it must be installed
separately in compliance with local regulations. Earthing
is a safety measure required by law, and must be
performed with particular care by a qualifi ed technician,
who must also check that the electricity supply
characteristics are correct.
The cable size used should be suitable for the appliance
load and in accordance with local regulations. Please
note the maximum cable sizes are 6mm
2
for the screw
terminals and 10mm
2
for the 3 pronged links.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your
electrical supply type (see fi g.).
Check that the links are correctly fi tted and
that the terminal screws are tight.
Secure the mains cable using the cable clamp.
This shows the single-phase connection.
Current Operated Earth Leakage
Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Oven Light
Press the oven light switch and check that the light is
working.
NB The oven light bulb is not included in the
guarantee
Hobplate
Turn on each plate in turn and check that it heats up.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
The clock must be set to the time of day before the
ovens will work.
Press and hold as shown.
At the same time, press - or + until the correct time
shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn
off the power supply for a minute or two and start again.
Turn on the oven and check that the oven fan starts
to turn and that the oven starts to heat up. Turn off the
oven.
Customer care
Please complete your details in this Guide, inform the
user how to operate the cooker and hand over the
Instructions.
Thank you.