Raritan Dominion KX II Quick Setup Manual - page 2
Dominion KX II Quick Setup Guide
2
QSG-DKX2-v2.5.0-0M-E 255-62-4022-00-RoHS
5. When connecting cables to the rear panel of the user
station or switch, drape them over the cable-support bar.
Front rackmount
Front rackmount
QS R ule
Rear Mount
Note: The Raritan device used in the diagrams shown here
are for example purposes only, and may not be a picture of
the KX II device. However, the mounting instructions are
consistent.
The steps correspond to the numbers shown in the rear
rackmount diagrams.
1. Secure the cable-support bar to the front end of the side
brackets, near the side brackets' “ears,” using two of the
included screws.
2. Slide the user station or KVM switch between the side
brackets, with its rear panel facing the cable-support bar,
until its front panel is flush with the back edges of the side
brackets.
3. Secure the user station or switch to the side brackets
using the remaining included screws (three on each side).
4. Mount the entire assembly in your rack and secure the
side brackets' ears to the rack's front rails with your own
screws, bolts, cage nuts, and so on.
5. When connecting cables to the rear panel of the user
station or switch, drape them over the cable-support bar.
Rear rackmount
Rear rackmount
QS R ule
Step 1: Configure the KVM Target Servers
For optimal bandwidth efficiency and video performance, KVM
target servers running graphical user interfaces such as
Windows
®
, Linux
®
, X-Windows, Solaris
™
, and KDE may
require configuration. The desktop background does not need
to be completely solid, but desktop backgrounds featuring
photos or complex gradients might degrade performance.
Ensure that the server video resolution and refresh rate are
supported by KX II and that the signal is non-interlaced. The
KX II supports these resolutions:
Resolutions
640x350 @70Hz
1024x768@85
640x350 @85Hz
1024x768 @75Hz
640x400 @56Hz
1024x768 @90Hz
640x400 @84Hz
1024x768 @100Hz
640x400 @85Hz
1152x864 @60Hz