Rasmussen CXF12 Installation Instructions Manual - Attention
3
WARNING! CHECK FOR PROPER VENTING
A properly sized, unobstructed chimney will normally vent all fumes and products of combustion. Any odor, smoke or
soot detected inside the room is an indication that the flue is not properly removing the combustion products.
SHUT OFF THE BURNER IMMEDIATELY! THE CAUSE OF THE VENTING PROBLEM MUST BE DISCOVERED
AND CORRECTED BEFORE CONTINUED USE OF THE GAS LOG SET.
Continued use with improper venting may cause damage to your fireplace, room and furnishings and could cause
serious illness. If improper venting is suspected, IMMEDIATELY HAVE LOG SET AND CHIMNEY FLUE SERVICED.
Periodically examine and clean the venting system. Once a year, a qualified agency should examine and clean the
venting system of your solid fuel burning fireplace.
ATTENTION
READ THESE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLY
REQUIRED TOOLS AND MATERIALS:
Screwdriver, Adjustable Wrench, Pipe Wrench,
Pipe Sealing Compound, Matches.
PREPARATION:
1. This Gas Log set must be INSTALLED IN A FULLY VENTED METAL OR
MASONRY FIREPLACE WITH A WORKING FLUE THAT IS SAFE FOR
BURNING A WOOD FIRE. The Flue MUST BE FREE OF ALL
OBSTRUCTIONS.
2. Turn off gas supply to fireplace.
3. Clean fireplace floor of any ashes.
4. Attach damper clamp over edge of fireplace damper blade as shown. When
installed properly, damper clamp prevents accidental full closure of damper. If
unable to install provided damper clamp, consult IMPORTANT
INFORMATION on front page of these directions for alternatives.
Damper Stop
Clamp
Damper
Chimney
Flue
Figure 1
STEP ONE: Burner Pan Assembly
Attaching Rear Burner Pan Leg
Photo 1
The Custom Embers Burner Pan has an adjustable rear leg
(see Photo 1) that provides either a flat or an angled surface, with two
different angles, depending on the orientation of the leg.
1. Insert two BOLTS through the WASHERS and the holes in leg at
desired height (see photos below). The height of the back wall of the
burner pan when flat on the ground is 2 5/8”; in the medium position is
3 ¾”; and is 5 1/8” in the high position (see photos 2, 3, and 4)
2. Wrench tighten NUTS securely to ensure mechanical strength and a
tight gas seal.
Photo 2
Pan Flat (install Bolts, Washers and
Nuts to make a gas-tight seal in the
holes in the back wall of burner.
Photo 3
Medium Position
Photo 4
High Position