Raven Cruizer II Operation Manual - page 13
1 2
2. The operator will be prompted to set
the marker location for the boundary
to be created.
The marker location is the point on the
guidance width which the Cruizer II
will map as the boundary of the
feature.
3. Select the center, left end, or right end
of the configured guidance width and
touch the
Green Check
to begin
recording the boundary.
4. Begin driving along the boundary keeping the selected reference point at
or near the desired zone boundary.
Note: While recording a zone boundary, select the
Pause
boundary
icon in the boundary mapping menu to pause recording of the feature
boundary. This is useful if the vehicle must drive away from a zone
boundary to refill a tank, etc.
Select the
Record No Spray Zone
icon to resume recording.
Note: Cruizer II will automatically end boundary recording if the vehicle
comes within one guidance width of the starting point.
5. To finish recording the boundary, touch
Stop
from the Mapping Tools
Menu.
Cruizer II will close the feature boundary by connecting the starting point
and the current vehicle location with a straight line.
While a guidance session may only contain a single field boundary, any
number of no spray zones or no plant zones may be recorded.