Raven Cruizer II Operation Manual - Accurow Setup
6
AccuRow Setup
Planter Row & Section Setup
Note: The
Sections
icon is only displayed in the
Tools Menu
if an
AccuBoom or AccuRow node is connected to the Cruizer II CANbus.
The
Section
configuration uses the programmed antenna
Fore/Aft
and
Left/Right
values to determine the relative location of each section
with respect to the GPS antenna. If the antenna position settings are
modified, verify that the section settings are correct before starting or
resuming an application.
1. From the home screen, touch
Tools
and select the
Sections
icon in the
Vehicle
menu. The
Rows setup screen will be
displayed.
2. Use the number of rows slider or
touch the keypad icon to the
right to set the number of rows
on the implement (maximum of
48).
3. Use the row spacing slider or
touch the keypad icon to the
right to set the spacing between
the rows.
Note: The currently selected units are displayed below the row spacing slider.
Be sure to enter the measured row spacing in the units displayed.
4. Touch the
Green Arrow
icon to advance to the Sections setup screen.
5. Touch the lock icon to the right of the sections slider to unlock the Sections
screen and allow values to be entered or modified.
Note: The keypad icon must be displayed before any values may be entered
or recalibrated.
Number of
Section Slider
Center Sections
Settings Lock