Raven Cruizer II Operation Manual - Accuboom Setup
3
AccuBoom Setup
Sprayer Section Setup
Note: The
Sections
icon is only displayed in the
Tools Menu
if an AccuBoom
or AccuRow node is connected to the Cruizer II CANbus.
The
Section
configuration uses the programmed antenna
Fore/Aft
and
Left/Right
values to determine the relative location of each section with
respect to the GPS antenna. If the antenna position settings are
modified, verify that the section settings are correct before starting or
resuming an application.
1. From the home screen, touch
Tools
and select the
Sections
icon in the
Vehicle
menu to display the sections setup screen.
2. Touch the lock icon to the right of the sections slider to unlock the Sections
screen and allow values to be entered or modified.
Note: The keypad icon must be displayed before any values may be entered
or recalibrated.
3. Use the number of sections slider to set the number of boom sections
(max. of 10) on the implement. Cruizer II automatically divides the
implement width (displayed in the lower, left information area) by the
number of sections entered.
Note: Touch the implement value in the lower, left information area to enter a
different implement width.
4. Below the sections slider, the width and offset of each section is displayed.
Section 1 corresponds to the left most boom section in a standard boom
configuration. Use the up or down arrows if necessary to view the settings
for each section.
Touch the width or offset values to display the on-screen keypad and enter
a new value.
5. If the sections are set end-to-end, centered on the swath midpoint, touch
the
Center Sections
icon to automatically align and center the boom
sections.
6. Touch the
Check Mark
to return to the tools screen or touch the
Home
Icon
to return to the home screen.
Number of
Section Slider
Center Sections
Settings Lock