Raymarine ST60 Tridata Owner's Handbook Manual - Auto Mode
6
ST60 Compass Instrument Owner’s Handbook
In locked mode you can use the
and
>
keys as necessary to change the locked
heading.
To leave locked mode press the
lock
key. The average error flashes on the digital
display for 5 seconds. If the average course steered has been to port of the locked
heading, the display shows - ; if the average course steered has been to starboard,
a positive value is displayed. If you press the
lock
key again within this 5 second
period, you re-enter locked mode with the previously stored heading as the locked
heading.
The average course error is reset to zero whenever the locked heading is changed.
Auto mode
The auto mode is activated automatically when the ST60 Compass instrument is
connected to a SeaTalk compatible autopilot.
Whenever the autopilot is engaged, the heading set by the autopilot is displayed
on the digital display and the analog pointer displays the autopilot’s course error.
Note:
In Auto mode, all ST60 Compass instrument key functions, except illumination, are
disabled.
1.3 Display illumination
When the instrument is first powered up, the display illumination is set to its
lowest (courtesy) level, to facilitate access to the keys.
To adjust the level of display illumination:
1. Hold down the
disp
key for approximately one second, to enter the illumina-
tion-adjust mode.
2. There are four preset illumination levels from L0 to L4. Momentarily press the
disp
key to cycle through these levels until you reach the level you want. The
selected level is transmitted to all other instruments on the Sea Talk bus.
3. Press any other key to leave the illumination-adjust mode.
Note:
The digital display will return to normal operation 7 seconds after the last key press.
A
LOCK
Auto lock display
D4450-1