Raymarine ST60 Tridata Owner's Handbook Manual - Connecting The Instrument
Chapter 3: Installation
23
Connecting the instrument
Introduction
The ST60 Compass instrument can be connected to SeaTalk as a repeater
instrument.
The ST60 Compass instrument can also be connected:
• As a stand-alone instrument connected directly to the Fluxgate Compass
transducer.
• To fulfil both slave (repeater) and master roles by being connected both to the
Fluxgate Compass transducer and to SeaTalk.
Instruments connected to SeaTalk derive their power directly from SeaTalk and no
separate power connection is necessary. Where a SeaTalk system includes an
autopilot, the power for the system is provided by the autopilot.
A range of Raymarine SeaTalk extension cables is available to connect separated
instruments. These cables are supplied with a SeaTalk connector fitted to each
end. A junction box can be used to join cables.
Signal connections
Make the necessary connections to your ST60 instrument (see the
Connection to
ST60 Compass instrument
illustration).
D4390-2
Cable from
Fluxgate Compass transducer
Connections to ST60 Steering Compass instrument
SeaTalk cable
SeaTalk cable
Screen
Blue
Green
Yellow
Red