Rioworks PURCA User Manual - Exit Discarding Changes
2-27
If you attempt to exit without saving, the program asks if you want to save
before exiting.
During boot up, PhoenixBIOS attempts to load the values saved in CMOS. If
those values cause the system boot to fail, reboot and press to enter
Setup. In Setup, you can get the Default Values (as described below) or try to
change the selections that caused the boot to fail.
??
Exit Discarding Changes
Use this option to exit Setup without storing in CMOS any new selections you
may have made. The selections previously in effect remain in effect.
??
Load Setup Defaults
To display the default values for all the Setup menus, select "Load Setup
Defaults" from the Main Menu. The program displays this message:
ROM Default values have been loaded!
Press
If, during boot up, the BIOS program detects a problem in the integrity of
values stored in CMOS, it displays these messages:
System CMOS checksum bad - run SETUP
Press
The CMOS values have been corrupted or modified incorrectly, perhaps by an
application program that changes data stored in CMOS.
Press
to resume the boot or
to run Setup with the ROM default
values already loaded into the menus. You can make other changes before
saving the values to CMOS.
??
Discard Changes
If, during a Setup Session, you change your mind about changes you have
made and have not yet saved the values to CMOS, you can restore the values
you previously saved to CMOS.
Selecting “Discard Changes” on the Exit menu updates all the selections and
displays this message:
BIOS Setup