Riso 3010 Troubleshooting Manual - page 14
1-6
ComColor Series Troubleshooting Guide 01
I
00-000>Information
These messages are displayed when maintenance of the machine is required.
The safety switch on the finisher
stacking tray is activated.
Check the tray.
Something may be obstructing the stacking tray. Make sure that there is nothing
placed below or near the tray.
This is Non-Riso ink cartridge.
Using Non-Riso ink may result in
serious damage to the printer.
Check your service provider's
warranty service agreement if any,
as damage caused by Non-Riso
supplies could be excluded from
coverage.
Do you wish to continue using this
cartridge?
A Non-RISO ink cartridge is installed. For details on what action to take, contact
your administrator.
This job has already been deleted.
The corresponding job was deleted on the console while the "Confirmation"
screen for a suspended job was being displayed or the setup screen displayed
when [Setting chg.] was pressed on the "Confirmation" screen.
Send the data again.
USB flash drive is not available.
A file having the same job name exists in the USB flash drive specified as
directory. To change the job name and save, press [Close] and scan the original
again. Otherwise, press [Close], change the destination to the internal HDD, and
scan the original again.
Data cannot be saved because there is not enough space in the USB flash drive.
Either press [Save to Internal HDD], or delete unnecessary data in the USB flash
drive to free up enough space, and save the data again.
USB flash drive is not found. Set
the USB flash drive again and
press "Retry" button.
A USB flash drive is not inserted in the machine.
• To save to a USB flash drive, insert it into the machine, and press [Retry].
• To change the storage directory to the internal hard disk, press [Save to
Internal HDD].
• To change the storage directory to a location other than the internal hard disk
or to cancel the save process, press [Cancel].
The inserted USB flash drive is not compatible with the machine.
Use a USB mass storage class device or a normal USB 1.1 or 2.0 flash drive.
Message
Action to Take
!!Maintenance!!
Call Service.
The time for periodic inspection has arrived. Contact your dealer (or authorized
service representative).
Replace the ink cartridge or
contact your administrator.
Install ComColor ink manufactured by RISO KAGAKU CORPORATION. If the
appropriate ink is not available, contact your administrator.
The drain tank must be replaced
soon.
Call service to prepare a new drain
tank.
Contact your dealer (or authorized service representative).
When the drain tank is full, printing cannot be performed. Be sure to
call for service when this message is displayed.
Transmission error to the Control
server.
Call Service.
Information may not have been sent correctly to the control server. Contact your
dealer (or authorized service representative).
Message
Action to Take