S.E. International Radiation alert Monitor 1000 EC Operation Manual - page 10
10
Menu Items
Auto Averaging
Turns auto averaging on or off. On by default.
Data Logging
Turns the internal memory on or off to record readings. Off by default.
Set To Defaults
Resets the Monitor 1000
EC
to the default factory settings. Doing this will not change the deadtime and
sensitivity, the time and date, or the data collection frequency.
Monitor 1000
EC
Factory Defaults
The factory default setting are:
Auto Average - On
Clicks - On
Audio Button silent mode - Off
Count Time - 10 minutes (600 seconds)
Alarm - Off - Default level - 1070 CPM (1.0 mR/hr, 1000 µR/hr, 10 µSv/hr, 17 CPS)
Data Logging Interval - 1 minute
When you access
Set to Defaults in the Menu on the instrument, all of the above settings will be returned
to the factory defaults, except
Data Logging. The Data Logging Interval can only be changed through the
software.
When you turn off the Monitor 1000
EC
, any settings you have made will come back to their last state except the
Audio Button silent function. To switch between silent and audio operation, which mutes everything except
the ALARM and OVER RANGE, press and hold the Audio Button for 3 seconds.
Setting the Internal Clock
It is not necessary to set the internal clock to start collecting data to memory, but it is recommended to
properly time stamp the data collection on your device to ensure the correct time and date in your collected
readings. You will need a copy of the Observer USB Software to set the internal clock. The latest version is
available at seintl.com/software. See Chapter 6: Observer USB Software.
Interfacing with an External Device
The USB jack on the right side provides an interface for use with the USB Observer Software. See Chapter 6
Observer Software. The USB connection will not charge the batteries.