Saabng SND-3080 User Manual - page 58
setup screen
_ setup screen
To set the alarm input
Select
The Alarm Input setup window appears.
When done, click [Apply].
Your settings will be saved.
Input device setup : Select an input
type according to the characteristics
of the alarm sensor on the rear of the
camera.
Off : Turns off the alarm input setting.
NO (Normal Open) : It is normally open, but if it is closed, an alarm will be triggered.
NC (Normal Close) : It is normally closed, but if it is open, an alarm will be triggered.
Activation time : You can set a time to execute a specific command when an
alarm occurs.
Always : Always executes the specified command when an alarm occurs.
Only scheduled time : Executes the specified command when an alarm occurs
only on a specified weekday, or time.
Action : You can set an action to execute when an alarm occurs.
Alarm output : Set the alarm output port to which the alarm signal is transferred.
Output duration : Set the period of time to output the alarm signal to the
specified alarm output port when an alarm occurs.
If a new alarm event is detected during the alarm output, the delay time is
recalculated based on the detection time of the recent alarm.
Alarm image transfer : If you select
or SMTP server according to the setting in
To set the motion detection function
Select
The Motion Detection setup window
appears.
When done, click [Apply].
Your settings will be saved.
m.d. function : If selecting
the motion detection function will be
activated; if selecting
not operate at all.
1.
2.
-
-
-
-
-
-
-
-
1.
2.