Saabng SND-3080 User Manual - page 81
of
105
English
_1
●
Appe
N
d
IX
PROBLEM
SOLUTION
I enabled Motion Detection Feature
under Motion Detection, but .jpg
files are not getting sent over FTP/
SMTP even after motion detection
occurs at the FT camera.
Verify the settings in the following sequence:
A. NTP must be properly configured.
B. Motion Detection Feature must be enabled.
C. Alarm Video Transmission must be enabled.
D. Check for scheduling conflict.
Is it possible to configure Motion
Zone with Motion Detection
Feature disabled?
Yes. Motion Zone can be configured independently of whether or not
Motion Detection Feature is in use.
A motion event took place but
didn’t trigger an alarm.
Check alarm output port settings.