Sabio SD-KN1 Assembly Manual - page 10
Rev. 1.4
Sabio Digital KN1 Assembly Guide
10 of 11
www.sabioproducts.com
Section 8.0 - Hard Disk Drive Installation
Installing the hard disk drive is a two-step process. The first process involves
assembling the hard disk drive into a kit. The second step is to install the
assembled hard disk drive kit into the lower chassis.
Section 8.1 - Assembling the Hard Disk Drive Kit
1. Remove the hard disk drive kit from unit by unscrewing the two screws
that secure it to the notebook chassis.
2. Place the hard disk drive into the kit tray making sure that the screw
holes are aligned properly with screw holes in the tray. (Illustration 8a)
3. Fasten four screws (M3.0x0.5+3.5I), two on each side, to attach the
hard disk drive to the tray. (Illustration 8b)
Illustration 8a – HDD Tray Illustration 8b – Location of Tray Screws
Section 8.2 - Installing the Hard Disk Drive Kit into the Notebook
1. Once the hard drive kit has
been assembled, carefully push
the kit into the drive bay until it
is connected.
2. Tuck the plastic tab used for
removing the hard disk drive
module away to prevent it from
interfering with the hard drive
door.
3. Using a small Phillips
screwdriver, secure the hard
drive by re-fastening two
screws (M2.5x6.0-I) to the hard
drive door. (Illustration 8c)
llustration 8c – Cover Screws Screws