Sabio SD-KN1 Assembly Manual - page 9
Rev. 1.4
Sabio Digital KN1 Assembly Guide
9 of 11
www.sabioproducts.com
6. Position keyboard flat into the keyboard opening and slide into place
under the two side latches. (Press right “Crtl” key to aide in positioning.)
7. Fasten two screws (M2.5x6.0-I) on top of keyboard to lock the keyboard
into the chassis.
8. Turn unit upside down and fasten
one screw (M2.5x11-I Nylock) to
the bottom case to secure the
keyboard from underneath the
chassis. The keyboard screw can
be found by looking for the “K”
label as shown in Illustration 7d
9. Replace the keyboard cover by
gently snapping it into place.
10. Re-fasten two screws (M2.5x4.0)
to the back (port side) of each
hinge to secure the keyboard
cover as shown in Illustration 7e.
Illustration 7d – Keyboard Screws
Illustration 7e– Location of Keyboard Hinge Screws