Sabio SD-KN1 Assembly Manual - page 11
Rev. 1.4
Sabio Digital KN1 Assembly Guide
11 of 11
www.sabioproducts.com
Section 9.0 - Installing the Optical Disk Drive
To install, simply slide the optical disk drive into the optical disk drive module
located on the right side of the lower chassis until it locks into place.
Section 10.0 - Wireless LAN Module Installation
1. Remove the wireless LAN module cover located on the bottom of the
lower chassis by unfastening the screw.
2. Install the wireless LAN module into the Mini-PCI slot by inserting the card
at a 45-degree angle into the slot. Like memory modules, the wireless
LAN card is keyed and can only be correctly inserted one way.
3. Gently press down on the card to seat it in the connector.
4. Make sure that the two tabs on
either side of the card are
inserted into the slots.
5. Connect the black and white
antenna wires to the connectors
on the wireless LAN card by
carefully matching the black wire
to the “main” connector and the
white wire to the “aux”
connector. Carefully arrange the
antenna cable on top of the
module. (#1, Illustration 10a) Do
not place it on the motherboard.
(#2, Illustration 10a)
6. Replace the cover and re-fasten
cover
screw.
Illustration 10 – Wireless LAN
Section 11.0 - Battery Pack Installation and Removal
1. To install the battery pack, turn the notebook upside down and slide it in
until it locks into place.
2. To remove the battery pack, turn the notebook upside down and at the
same time, slide the battery latch open and then lift out the battery pack.