Sabio SD-KN1 Assembly Manual - page 7
Rev. 1.4
Sabio Digital KN1 Assembly Guide
7 of 11
www.sabioproducts.com
Section 6.0 - Memory Module Installation
There are two memory expansion SODIMM slots on the SD-KN1 notebook, and
the notebook comes standard with no memory installed. The memory capacity is
upgradeable up to 2GB using two 1025MB memory modules. To install a memory
module follow these basic steps:
1. Remove memory module cover (same as the CPU thermal module cover)
on the bottom of the notebook using a small Phillips screwdriver.
2. Notice that each memory module is keyed and can be only installed
properly by aligning the notches of the module with the guides in the
SODIMM connector.
3. Insert the memory module at a 45-degree angle into the connector and
press down until the module clicks into place. (Illustration 6)
4. Replace memory module cover.
Illustration 6 – Insert memory module at 45-degree angle