SAFERA PCU3 Installation Manual - page 12
23
22
4. INSTALLING THE WATER LEAKAGE
SENSOR (optional)
Stove Guard can be equipped with max.
four SAFERA Water Leakage Sensors. The
sensors are placed in the typical leakage
areas, e.g. under the dishwasher or sink.
Attach the sensors
Ⓕ in place.
1
ѧ HINT
If the sensor is left wet, the appliance will
give another alarm in an hour after signing
off the previous one.
Attach the plug
Ⓖ of the leakage
sensor to the Power Control Unit
Ⓗ.
2
If there is an extra sensor, its plug
Ⓖ
is connected to the connector
Ⓘ of
the previous sensor.
3
Check the operation of the furthest
sensor
Ⓕ by placing a damp paper to-
wel against it for 15 seconds. When
the water is detected, the Sensor unit
Ⓐ
gives a sound signal, the warning light for
water leakage
❻ blinks and light panels ❽
blink blue.
4
Reset the leakage alarm by pressing
the OK button
❷. Clean and dry the
sensor.
5
C
G
H
I
F