Saga SAGA-1350I User Manual - 6.5. Settings Mode

6.5. Settings Mode

You can press the Mode key multiple times in Offline mode to toggle through the 

following menus:

Pressure

Use the Left/Right keys to set the pressure in units of one gram; the valid range of 

values is between 0g and 510g, 2g/step.

When setting the cutting pressure, please note that the correct setting mainly

depends on the knife holder, the position of the knife, and the loaded media.

These settings are subject to variation.

Speed

Again use the Up/Down keys on the operating panel to set the speed.

X-Scale/Y-Scale

Do not change the X and/or Y-Scale values as they are used to compensate for wear 

and tear of the transport belts. Only change these settings, if plots become distorted.

Baud

The baud rate is the communication speed for the cutting plotter and the serial port on

your computer. This setting must reflect the baud rate set in the properties dialog for 

your COM port, or in the softwares. Value of 9600/19200/38400 are typically set, but this 

can vary depending on your COM port setting.

Additional settings in the display:

ON/Offline (pause the plot)

Press this key to pause the current plot; you can then modify settings performed

previously. The display now shows the force and the speed; both values can be modified.

Specialized in developing, designing and manufacturing kinds of vinyl cutter