Saga SAGA-1350I User Manual - Step2
of
27
support for the left side
bottom stand
screw
screw
Specialized in developing, designing and manufacturing kinds of vinyl cutter
Step2
Place the stand beam upright on the T-stand and put the screws into the holes,
but do not tighten them at this step.Repeat the same steps with another stand beam.
stand beam
T-stand for right side
T-stand for left side
3. Floor Stand Installation
Step1
Position the support for the left side
perpendicularly to bottom stand and
place the screws into the holes. Tighten
them to form a left side T-stand
Repeat the same steps with the support
for the right side.