SAGEMCOM D16V User Manual - page 16
- 16 -
9.4.
Modifying the country
1. Press
. Select "
advanced set" using the or key, press
.
2. Using the or key, select "
country". Press
.
3. Enter the base master PIN code (default 0000). Each time a digit is entered the «_» is replaced by
a «*». Press
key to confirm.
4. Using the or key, select the country where you will use the telephone. Press
.
5. A confirmation screen appears, press
.
The message "
wait.." appears on the screen. You will hear a confirmation tone.
9.5.
Restoring the Handset / Base Default Settings
To restore the factory settings for your Handset or your Base:
1. Press
. Select "
advanced set" using the or key, press
.
2. Using the or key, select "
reset". Press
.
3. A confirmation screen appears, press
- If you want to confirm the reset, press -
To cancel the reset, press
.
English
4. You will hear a confirmation tone: the settings of your phone are restored to their initial values.
9.6.
Prefix ( Depending on Country)
If a PABX is used in a private network, you can program the outside call prefix.
This function sets:
-
the PABX prefix number: this number will be added at the beginning of the number you
dialled.
-
the number to be detected: if the number you dialled starts with the recorded sequence,
this sequence will be automatically deleted.
These two settings are not applied if number you dialled starts with "#" or "*".
1. Press
. Select "
advanced set" using the or key, press
.
2. Using the or key, select "
auto prefix". Press
.
3. Select "
detect digit" to define the number giving you access to the outside line.
4. Select "
prefix" to specify the «digits before prefix».
5. Press
key to confirm your selection. You will hear a confirmation tone.
9.7.
Flash timing
If you connect your telephone to a private automatic branch exchange or use it in a foreign country,
you may need to modify the flash duration in order to use your telephone correctly with regard to
the following functionalities: outgoing 2nd call, incoming 2nd call, conference call.
Contact your administrator, who will supply the appropriate time period, and proceed to the new
settings.
.
.