SAGEMCOM D16V User Manual - page 25
- 25
D16V/D18V/D21V
English
11.7.
15.2.2. Telephone
Deleting messages
11.7.1. Deleting the current message
Problem
Solution
During the pNo dial tone layback of the message, press the
x
Check installation: key.
The message in progress is deleted: - Is the base power cord connected to a
- If you have other messages, the next message working outlet? is broadcast.
- Otherwise, the answering machine returns to standby mode. - Is the telephone line cord
connected to the base unit and the wall jack?
11.7.2. Deleting all messages already played back
x
Disconnect the base from the wall jack and
connect another phone to the same jack. If 1. In standby mode, hold down the
key until you
hear a beep.
there is no dial tone in the second phone, the
This beep informs you that all your messages already played back have been deleted.
problem might be your wiring or local service.
- OR -
x
Is the handset out of range of the base?
answ machine "using the
x
Make sure the batt or key, press ery is pr.
operly charged
1.
Press
. Select "
(12 hours).
2.
Select "
delete all" using the or key, press
x
Is the battery pack installed correctly? .
x
Did the IN USE indicator come on?
3.
Press
to confirm deletion.
A beep indicates that all messages already played The battery may need to be charged. back
have been deleted.
Dial tone is OK, but can’t dial out
x
Make sure the tone/pulse setting is correct.
12.
Handset does not ring
Answering machine setup
x
Make sure the
RINGER setting on the
12.1.
Number of rings
handset is programmed to ON.
This parameter enables you to set the number
x
of times your teYou may have too malephone rings
before the ny extension phones on your line. Try unplugging some phones. answering machine
answers a call. The number of rings can be set between 2 and 7.
You can also select the "
ECONOMY"mode. The "ECONOMy
x
See
solutions
for
"
mode
automatically
«NO dial tone».
determines the
number of rings: If there are You experience static, noise no new messages on the or fading in
x
Is handset out of range? answering machine, the number of rings will be 4, otherwise the
number of rings will be 2. Move closer to the base. and out
x
Does the base need to be
relocated?
1.
Press . Select "
answ machine " using the
x
Charge battery.
or key, press .
x
Make sure base is not plugged into an outlet
2.
Select "
settings" using the or key, press with another household appliance. .
3.
Select "
ring delay" using the or key, press
.